Putting a steering wheel cover on may seem like a simple task, but it can be tricky if you’re not sure what you’re doing. By following these easy steps, you can get a perfect fit that will protect your steering wheel from dirt, wear, and tear.
Before you start, you’ll need a few things: a steering wheel cover, a pair of scissors, and a thin screwdriver or other sharp object. First, remove the old steering wheel cover, if there is one. Then, line up the new steering wheel cover with the center of the steering wheel. Pull the cover over the steering wheel, starting at the top and working your way down. Use the screwdriver or other sharp object to tuck the excess material into the gap between the steering wheel and the cover.
Once the cover is in place, adjust the fit by pulling it tighter or loosening it as needed. The cover should be snug but not so tight that it’s difficult to turn the steering wheel. Finally, trim any excess material around the edges of the cover with the scissors. Sit back and revel in the satisfaction of a job well done.
Removing the Old Cover
The first step is to remove the old cover from your steering wheel. This can be a bit tricky, but with a little patience and finesse, it’s definitely doable. Before removing it completely, we recommend taking photos of how your old cover was positioned, this could help you when installing the new one. Here are a few tips for removing the old cover:
Gather Your Tools
Before you start, you’ll need to gather a few supplies. You’ll need a butter knife, a screwdriver, and perhaps some pliers.
Start by Removing the Trim
The first step is to remove any trim pieces that are covering the steering wheel. These pieces are usually held in place by screws or clips. Use a screwdriver or pliers to remove the screws or clips, and then carefully pry the trim pieces off.
Disconnect the Airbag Module
If your vehicle has an airbag, you’ll need to disconnect the airbag module before you can remove the steering wheel cover. The airbag module is usually located in the center of the steering wheel. Consult your vehicle’s service manual for specific instructions on how to disconnect the airbag module.
Pull the Old Cover Off the Steering Wheel
Once the airbag module is disconnected, you can pull the old cover off the steering wheel. Start by pulling the cover off at the top of the steering wheel. Then, work your way around the steering wheel, pulling the cover off as you go.
How To Put A Steering Wheel Cover
Putting a steering wheel cover is a great way to add a personal touch to your car and protect your steering wheel from wear and tear. It’s also a relatively easy project that can be completed in just a few minutes.
Here are the steps on how to put a steering wheel cover:
- Center the steering wheel cover over the steering wheel.
- Starting at the top, pull the cover over the steering wheel and smooth it down.
- Continue pulling the cover over the steering wheel until it is completely in place.
- Use your hands to smooth out any wrinkles or air bubbles.
- Once the cover is in place, you can use a zip tie or other fastener to secure it.
People Also Ask About How To Put A Steering Wheel Cover
What type of steering wheel cover is best?
There are many different types of steering wheel covers available, so it really depends on your personal preferences. Some people prefer leather covers, while others prefer fabric or neoprene covers.
How often should I clean my steering wheel cover?
You should clean your steering wheel cover regularly to prevent the buildup of dirt and bacteria. You can clean it with a mild soap and water solution or a commercial steering wheel cleaner.
Can I put a steering wheel cover over a steering wheel that has buttons?
Yes, you can put a steering wheel cover over a steering wheel that has buttons. However, you may need to make some adjustments to the cover so that it fits properly.
